Problem With Number Of sms's

Verfasst am: Sa Sep 15, 2007 23:58

Hi,

I have a SE W850i
On there I have 849 sms.
I need to get them all of the phone and printed out as they are to be used in a court case.

When MPE loads my sms in says download X of 849 messages, However when it gets to about number 160 it stops then opens the messages inbox.

At the bottom of the page it says
message counter: 0 and then x/78 (Where X=message number I have highlighted)

Is there a way I can get all of my messages to be displayed?

Also some of the messages are multiple sms's IE where one sms contains 3 sms's as its so long, The full txt of this is not displayed I get (...) instead which it tells me that if I open the message. Is there a way to view the whole message ?

Here are my settings for MPE

Com port: 4 Sony Ericsson USB Data Modem
Baud Rate: 921600
OBEX: 4096
Stable connection is checked, If I dont have this checked then MPE wont connect to my phone. I get a phone can not be identified error message.

My Fone is SE W850i
OS - XP Media Center SP2
MPE Version - 1.6.3
Connection Type - USB
Firmware - R1ED001
LAC - 9D81 / 00075A09

If I select Com7 Sony Ericsson USB Device Manager MPE starts to downloads the messages, it gets to number 570 stops for a few seconds then asks if i want to copy or delete from archive after I make a selection MPE just closes itself or is shut down by windows (Not sure which it is)

You may view the Debug.txt file @ www.get-wireless.co.uk/Debug.txt

Also the sms that I need to get start on the 27/8/2007 upto present,
Yet the messages displayed show some on the 27/08/2007 and then jump to the 03/09/2007 and I know there are messages in between those dates.

Regards
Shaunie

Verfasst am: So Sep 16, 2007 11:55

Hy

Disable stable connection and find the solution why it doesn't work without stable connection. Kill the process "ehtray.exe" on your system - it can block the Ports. And read the FAQ. If you have further problems - then post the logfile.

Verfasst am: So Sep 16, 2007 13:13

Hi,

I have disabled the stable connection and still cannot get MPE to connect. Each time it says phone could not be identified.

I dont have ehtray running. I have also killed all processes that are not system critical from task manager.

I have read this http://www.fjsoft.at/forum/viewtopic.php?t=42 and there is nothing in there that helps with my problem Sad

logfile at www.get-wireless.co.uk/Debug.txt

Thanks
Shaunie

Verfasst am: So Sep 16, 2007 13:50

If you use the original USB-Cable which was delivered with the phone then you have a problem with the drivers.

Zitat:

12:05:26.25 Avaiable Ports: COM3=Winachsf0; COM4=\Device\000000d8; COM5=\Device\000000da; COM6=\Device\000000dc; COM7=\Device\000000dd;

This is your machine. With correct installed drivers it should look like this:

Zitat:

12:05:26.25 Avaiable Ports: COM3=Winachsf0; COM4=\Device\se38mdm0; COM5=\Device\se38mdm1; COM6=\Device\se38obex0; COM7=\Device\se38mgmt0;

Verfasst am: So Sep 16, 2007 21:10

Thanks,

I managed to do it via bluetooth instead thanks very much for your help its is very much appreciated

Informationen zum Datenschutz auf dieser Website