FJ Software

Hi,

I have a SE W850i
On there I have 849 sms.
I need to get them all of the phone and printed out as they are to be used in a court case.

When MPE loads my sms in says download X of 849 messages, However when it gets to about number 160 it stops then opens the messages inbox.

At the bottom of the page it says
message counter: 0 and then x/78 (Where X=message number I have highlighted)

Is there a way I can get all of my messages to be displayed?

Also some of the messages are multiple sms's IE where one sms contains 3 sms's as its so long, The full txt of this is not displayed I get (...) instead which it tells me that if I open the message. Is there a way to view the whole message ?

Here are my settings for MPE

Com port: 4 Sony Ericsson USB Data Modem
Baud Rate: 921600
OBEX: 4096
Stable connection is checked, If I dont have this checked then MPE wont connect to my phone. I get a phone can not be identified error message.

My Fone is SE W850i
OS - XP Media Center SP2
MPE Version - 1.6.3
Connection Type - USB
Firmware - R1ED001
LAC - 9D81 / 00075A09

If I select Com7 Sony Ericsson USB Device Manager MPE starts to downloads the messages, it gets to number 570 stops for a few seconds then asks if i want to copy or delete from archive after I make a selection MPE just closes itself or is shut down by windows (Not sure which it is)

You may view the Debug.txt file @ www.get-wireless.co.uk/Debug.txt

Also the sms that I need to get start on the 27/8/2007 upto present,
Yet the messages displayed show some on the 27/08/2007 and then jump to the 03/09/2007 and I know there are messages in between those dates.

Regards
Shaunie

Hy

Disable stable connection and find the solution why it doesn't work without stable connection. Kill the process "ehtray.exe" on your system - it can block the Ports. And read the FAQ. If you have further problems - then post the logfile.

Hi,

I have disabled the stable connection and still cannot get MPE to connect. Each time it says phone could not be identified.

I dont have ehtray running. I have also killed all processes that are not system critical from task manager.

I have read this http://www.fjsoft.at/forum/viewtopic.php?t=42 and there is nothing in there that helps with my problem

logfile at www.get-wireless.co.uk/Debug.txt

Thanks
Shaunie

If you use the original USB-Cable which was delivered with the phone then you have a problem with the drivers.

12:05:26.25 Avaiable Ports: COM3=Winachsf0; COM4=\Device\000000d8; COM5=\Device\000000da; COM6=\Device\000000dc; COM7=\Device\000000dd;

This is your machine. With correct installed drivers it should look like this:

12:05:26.25 Avaiable Ports: COM3=Winachsf0; COM4=\Device\se38mdm0; COM5=\Device\se38mdm1; COM6=\Device\se38obex0; COM7=\Device\se38mgmt0;

Thanks,

I managed to do it via bluetooth instead thanks very much for your help its is very much appreciated