Chinese character

Guest · Beitrag von **Guest** » Mo 29. Dez 2008, 17:10

Hi, Simplified Chinese SMS can be read when it is not opened up and became unreadable when the SMS is opened. SMS pop up cannot be read as well. In addition, I cannot send SMS using MPE. Will future enhancement support this language?

Khosrow · Beitrag von **Khosrow** » Mo 29. Dez 2008, 17:32

Check this post and change the "language for non Unicode programs" from whatever it is to Chinese:
http://www.fjsoft.at/forum/viewtopic.ph ... highlight=

Regards,
Khosrow

Beitrag von FJ » Mo 29. Dez 2008, 20:18

@Khosrow: Basicly you are right, but this matches not to chinese charsets.

If your pC is set to Chinese then the PC works in another String-Mode (DBCS - Double Byte Character system). If your PC works in this mode then maybe the SMS will be shown OK, but alot of other things will not work. i tried to fix this issue but its too much work, everytime i fix one problem related the DBCS-Mode another problem appears.

In the listview the message should be displayed right, cause this control is fully unicode compatible. You can use CTRL+C to copy the text.

Guest · Beitrag von **Guest** » Di 30. Dez 2008, 08:33

FJ hat geschrieben:@Khosrow: Basicly you are right, but this matches not to chinese charsets.

If your pC is set to Chinese then the PC works in another String-Mode (DBCS - Double Byte Character system). If your PC works in this mode then maybe the SMS will be shown OK, but alot of other things will not work. i tried to fix this issue but its too much work, everytime i fix one problem related the DBCS-Mode another problem appears.

In the listview the message should be displayed right, cause this control is fully unicode compatible. You can use CTRL+C to copy the text.

Yes. List view desiplays correctly. Thanks for the fast response. It would be good to type directly and sms pop up.