MPE answers calls automatically

Diquito · Beitrag von **Diquito** » Mo 25. Feb 2008, 15:30

Hi..
I have MPE set up via bluetooth and I use the audiogaetway connection to be able to use the pc as headset.. everything works really fine except that when i receive a call I only get one ring in the software and the the software answer the call.. is there any setting i the MPE software that can remove the autoanswer?

Beitrag von FJ » Mo 25. Feb 2008, 17:56

MyPhoneExplorer doesn't answer automatically. There is a setting in the phone to auto-answer calls if a hands-free is connected.

Diquito · Beitrag von **Diquito** » Di 26. Feb 2008, 07:31

Yes I know and that setting is not enabled.
So it is the software that answers.... It's a K800i I have and I've checked all settings that could have autoanswer and disabled them and still MPE allows one ring and then it answers? Can it be that I have missed some settings i the phone?

Beitrag von FJ » Di 26. Feb 2008, 09:13

There are some diffrent places for the same setting in the phone. Check it in your profile and in the Bluetooth-settings.

Gast · Beitrag von **Gast** » Di 4. Mär 2008, 14:24

Hi.
I did a complete factory restore on the phone, But the application stills answer.
I have the phone set up as an audio gateway though can that have something to do with it.

Beitrag von FJ » Di 4. Mär 2008, 15:01

MYPHONEEXPLORER NEVER ANSWER CALLS AUTOMATCALLY.
If you don't believe it you can take a look at the logfile.

Gast · Beitrag von **Gast** » Di 4. Mär 2008, 16:03

This is what the log says when someone rings... can you see what the problem is?

16:01:40.47 [RX]: +CSQ: 99,99
16:01:40.49 [RX]: OK
16:01:46.02 [RX]: RING
16:01:46.03 [RX]: *ECAV: 1,6,1,,,"087750398",129
16:01:46.64 Downloader: RC=6 BytesMax=73 BytesTMP=73 URL=zensiert
16:01:47.72 [RX]: *ECAV: 1,3,1
16:01:50.49 [TX]: AT+CBC
16:01:50.52 [RX]: AT+CBC

Zayoos · Beitrag von **Zayoos** » Di 4. Mär 2008, 16:51

The Bluetooth software alone answer a call automatically. If I remember correctly, call will be answered even if You don't use MPE in that moment.

Gast · Beitrag von **Gast** » Di 4. Mär 2008, 17:02

Aahhh.. is there any way to configure this not to answer automatically?

Beitrag von FJ » Di 4. Mär 2008, 18:20

There are some diffrent places for the same setting in the phone. Check it in your profile and in the Bluetooth-settings.

The above log contains no answercommand (it would be "[TX]: ATA")

Zayoos · Beitrag von **Zayoos** » Di 4. Mär 2008, 20:06

Anonymous hat geschrieben:Aahhh.. is there any way to configure this not to answer automatically?

If the Bluetooth software you are using don't have an option to configure it, then there is no way of doing that.

I don't know if any of the BT software available have that kind of option.