After automatic disconnect and connect (when serial or usb-to-serial cabel was disconnected and connected again) the baudrate is always only 9600 kbps! Tthe old baudrate (e.g. 11500) is NOT set.
My phones: T630i and K700i. MPE 1.6.4, XP SP2.
Low baudrate ater reconnect
The basic bug is fixed in the next update. Thank you for the tipp.
If the drivers do not send a notification to MyPhoneExplorer when the device is reconnected then the auto-reconnect works only if the app is in traymode or minimized. I had to do this cause in cooperation with Bluetooth-Service the BT-Software would block MyPhoneExplorer for some seconds on a reconnect-try. MyPhoneExplorer checks the connection and try to reconnect every ten seconds. On the newer models the reconnect works usually under 1 seconds delay (based on the notification from the USB-Driver)
If the drivers do not send a notification to MyPhoneExplorer when the device is reconnected then the auto-reconnect works only if the app is in traymode or minimized. I had to do this cause in cooperation with Bluetooth-Service the BT-Software would block MyPhoneExplorer for some seconds on a reconnect-try. MyPhoneExplorer checks the connection and try to reconnect every ten seconds. On the newer models the reconnect works usually under 1 seconds delay (based on the notification from the USB-Driver)