Problem with Seamonkey 2.49 Contacts with MPE 1.8.9 - Fixed?

[KentonS]

I just upgraded from 1.8.8 to 1.8.9. When I synchronized Phone contacts with my Seamonkey contacts, a screen popped up in MPE saying "The MyPhoneExplorer-Extension is either not installed or is too old. Install the newest plugin now?" I selected OK and was instructed to close Seamonkey, which I did. The synchronization completed successfully.

Thereafter, every time I attempt to sync contacts, the same thing happens: I have to close Seamonkey to allow the newest plugin to be (re)installed, synchronization completes successfully, and I have to bring Seamonkey back up. I have verified that the MPE Extension 2.0.20 is installed in Seamonkey.

Am I doing something wrong?

Thanks very much for any advice anyone can offer!
Kenton

[KentonS]

I restored MPE version 1.8.8, and everything works well with that version.

The Seamonkey extension is still at 2.0.20, which implies that the problem is not with the extension.

[KentonS]

Is this receiving any attention? Is anyone else experiencing this problem?

[StarLogger]

Is this receiving any attention? Is anyone else experiencing this problem?

Yes, same problem here
Using SeaMonkey version 2.49.3 (32 Bit)
OS: Windows 10 - 64 bit

[KentonS]

Has this been fixed? I'm reluctant to install any updates until I know it has.

Thank you,
Kenton

[KentonS]

Has this been fixed? I'm reluctant to install any updates until I know it has.

Thank you,
Kenton

Anybody?

[StarLogger]

Has this been fixed? I'm reluctant to install any updates until I know it has.

Thank you,
Kenton

Anybody?

I have checked with the latest version 1.8.11
I also checked to see if there was a newer version of
the SeaMonkey MPE extention, there was no update
The same problem exists
I even used Revo Uninstaller to perform a clean
uninstall of MPE 1.8.9 before hand before installing
Makes 0 difference

[KentonS]

I have checked with the latest version 1.8.11
I also checked to see if there was a newer version of
the SeaMonkey MPE extention, there was no update
The same problem exists
I even used Revo Uninstaller to perform a clean
uninstall of MPE 1.8.9 before hand before installing
Makes 0 difference

Disappointing, but thanks very much for the update!

[KentonS]

Has this defect been fixed in Version 8.1.12? I'm reluctant to install any updates until I know it has.

Thank you,
Kenton