FJ Software

Connect by Bluetooht

PcSuit&mRouter install and work

In Bluetooht\My Phone service m-Router on COM7 - connected successfully

It was tried on different options:
1. CheckBox On/Off - State connection
2. Any Speed Baud Rate
Result:
13:45:22.00 Avaiable Ports: COM1=\Device\Serial0; COM6=\Device\BtPort1; COM7=\Device\BtPort2; COM8=\Device\BtPort0; COM9=\Device\BtPort3; COM10=\Device\BtModem0;
13:45:22.00 Port 7 wird geoffnet...
13:45:27.25 Einstellungen werden gesetzt (921600, N, 8, 1)
13:45:27.25 Puffer werden gesetzt...(16384)
13:45:27.25 Settimeout: RT=2000 WT=200
13:45:27.75 Port 7 wurde geoffnet !
13:45:27.83 [TX]: AT+CGSN
13:45:29.83 ReadFile Fehler: Systemerror: 0 [Operation is successfully finished]
13:45:29.84 ErrMsg: Phone could not be identified
13:45:32.78 Port 7 wird geschlossen
13:45:32.78 Port wurde geschlossen

Help me, please
Best regards, Aleks

Bluetooth for Symbians is quite tricky and therefor it is not officially supported (only USB-Connection is supported).
But you can find some threads by using the board search.

weinbi hat geschrieben:Bluetooth for Symbians is quite tricky and therefor it is not officially supported (only USB-Connection is supported).
But you can find some threads by using the board search.

When official support is expected?

P.S. USB & Bluetooth Connection use virtual COM port Windows sysem. IMHO, to program should be all the same what port to use

Its not a question of support - it is supported and it works, but its tricky to setup. Cause of this its note recommened - and as official statement: not supported.

This thread should help you: http://www.fjsoft.at/forum/viewtopic.php?t=5911
But don't expect my help if you have problems with it.

That's what I wanted to say!