FJ Software

If your phone is connected via bluetooth or cable and computer goes on standby when it wakes, if the phone is not connected to the cable or the bluetooth is off, MPE hangs and even prevents PC from going standby again
Even the MPE process couldn't be stopped is there any other process related to mpe that ending it will help?

Normally if a device is not reachable then the driver gives back an error. In your case the driver blocks MyPhoneExplorer. Especially when you are using Bluetooth its a known problem which happens with some Bluetoothstacks but not on all. If you are using USB it should not happen - does it really happen if you ste the used COM-Port to the USB-Port ?

Yes It happens if the computer recovers from standby and the phone is not connected to the usb, It wouldn't be a big problem if you tell me which process I should stop, because If I turn my pc to standby again, It will never go on standby and I have to reset the pc.
I forgot to write that in some few cases it doesn't hang, but the blue screen apears

It depends on the drivers, they cannot be closed with the taskmanager. You could activate "Disable automatic connect/reconnect" in the settings.

Dear FJ,
thank you for bringing this great software.
MPE hanging when trying to access contacts from phone, but sometimes from sim is accessible.

always hanging during multisync if the sync contacts or organiser or messages is checked on.

not being able to connect with cable even after i downloaded the driver from the SE website.
is it necessary to install sorny ericsson Pc suite?

I am using SE W302, win Vista Home Premium

best regards

You need just the drivers, not the pc suite.
Do you have the latest drivers?

@salkis: please post the logfile after MPE hangs (%appdata%\MyPhoneExplorer\Debug.txt)

I get an OBEX PROTOCOL COULD NOT BE INITIALISED. Obex error:

I have the COM8 service correctly installed. I rebooted, pulled my battery out, I tried everything.

im trying to use with a bluetooth service:(

First pair your phone with the PC, then activate the service "Serial connection" in your Bluetoothsoftware. And the next time please read the FAQ before.