Phone could not be dentified
Verfasst: Mo 4. Feb 2008, 00:47
I installed 1.6.6 I get the msg:
I redid the device detection and the phone was found at bluetooth dun port 10, as it was before already.
This is the last part of the log:
when I try to connect.Phone could not be dentified
I redid the device detection and the phone was found at bluetooth dun port 10, as it was before already.
This is the last part of the log:
What can be the cause?00:41:26.18 OK pressed in settingswindow
00:41:26.21 Set first swap of settings
00:41:26.21 Apply new holidays
00:41:26.21 DoItemUpdate
00:41:26.23 DoItemUpdate fertig
00:41:26.23 Holidays applied
00:41:26.23 Second swap of settings set
00:41:26.23 Everything is done
00:42:05.76 Avaiable Ports: COM1=\Device\Serial0; COM2=\Device\Serial1; COM3=\Device\Serial2; COM4=\Device\Serial3; COM5=\Device\Serial4; COM6=\Device\Serial5; COM7=\Device\Serial6; COM8=\Device\Serial7; COM9=\Device\Serial8; COM10=\Device\Serial9; COM11=\Device\Serial10;
00:42:05.76 Neue COM-Bibliothek wird verwendet
00:42:05.76 Settimeout: RT=2000 WT=200
00:42:06.26 Port 10 wurde geöffnet!
00:42:06.26 [TX]: AT+CGSN
00:42:06.26 Systemerror: 0 [De bewerking is voltooid.]
00:42:06.27 ErrMsg: Phone could not be identified
00:42:10.55 Port 10 wird geschlossen