FJ Software

How can I keep MPE WiFi active all the time.
Now it disconnects after 15 minutes

See https://www.fjsoft.at/forum/viewtopic.php?t=373

https://www.fjsoft.at/forum/viewtopic.php?t=373 hat geschrieben:Verbindung nach 5 Minuten nur dann trennen, wenn Handy nicht am Ladegerät hängt:
Code:

Code: Alles auswählen

[Main]
DisconnectOnInactive=2

which translates as Disconnect after 5 minutes only if the phone is not connected to the charger

When not connected, after a while MPE on my phone exits and I have to start MPE on the phone to connect to it.
I would like to have MPE always active on my phone.

Without a connection the MPE client will be closed after 15 minutes, that is correct and will not change.
If you don't want to close the client on your phone, you should keep the connection
Normally, if necessary, the client on the cell phone should be started again automatically using a Google push command

MPE does not start automatically via the computer with a fixed WiFi address.
Updated from MPE 2.0 to MPE 2.1 on the computer, now it works fine.
Saw an article on the forum about this.
Thank you!