FJ Software

Hey there admins,

Here is a bug in 1.8.2.:

The areacode of Denmark is STILL set to "0000" despite promises to fix it. Please see postinghttp://www.fjsoft.at/forum/viewtopic.ph ... light=0000 for details.

Aside from that, thank you for a wonderful product ....

Kind regards,
Mark

Are you sure ? Maybe it was added by 1.8.1 earlier. Just checked the source again: In MyPhoneExplorer 1.8.2 there is never the areacode field set to 0000, no matter which country is used

FJ hat geschrieben:Are you sure ? Maybe it was added by 1.8.1 earlier. Just checked the source again: In MyPhoneExplorer 1.8.2 there is never the areacode field set to 0000, no matter which country is used

Hey there

I am 100% percent sure.

I use Outlook 2010 and after every time I have synced between my phone and my Outlook, the area is reset to "0000"

I have created a link to a screen-shot here:

http://din-terapeut.dk/outlook.jpg

Kind regards,
Mark

FJ hat geschrieben:Are you sure ? Maybe it was added by 1.8.1 earlier. Just checked the source again: In MyPhoneExplorer 1.8.2 there is never the areacode field set to 0000, no matter which country is used

Are you suggesting that I should remove 1.8.1 and then reinstall 1.8.2. manually?

If so, is there a way to clean-remove and then clean-install?

Thank you so much once again

Kind regards,
Mark

Strange, i also checked again....
Are you sure that MPE 1.8.2 is installed on your PC (check the About.... Screen)

FJ hat geschrieben:Strange, i also checked again....
Are you sure that MPE 1.8.2 is installed on your PC (check the About.... Screen)

1.8.2. yes I have checked