FJ Software

I have just had my (ancient) K610i repaired and I still get the same error message of unable to connect, OBEX etc., although when I search for the device it finds the phone well. This is really irritating.

I must say that my USB cable does not always charge the phone, sometimes it does and sometimes not.

A suggestion, when the phone is disconnected from the cable, when the program is open, I receive numerous error messages and it's difficult to exit the program. In my opinion, if the connection breaks, the program needs to simply, end the connection and idle.

Otherwise I thoroughly enjoy the program and thank you for it.

Cause your problems with unstable connection: It often helps to clean the connector of the phone

A suggestion, when the phone is disconnected from the cable, when the program is open, I receive numerous error messages and it's difficult to exit the program. In my opinion, if the connection breaks, the program needs to simply, end the connection and idle.

If the phone is just connected to phone without doing operations then myPhoneExplorer will not show any error, in this case it just disconnects