Multipart SMS

[Paulg]

Using mpe Ver 1.54 and Sony W810

If I use mpe to type a multipart SMS it sends the message ok but if I try to view the sent message on the phone it only dispays the last part of the message. Also if I type the multipart sms on the phone and then sync to mpe only the last part is shown in mpe.

Paul

[Gast]

Sorry should have mentioned using usb connection with win XP

[FJ]

Displaybug inside the phone. Restart the phone and then the message is shown correct.

[Paulg]

OK, thanks for that. Works Ok

Paul

[Gast]

I had the same problem. I like to write the long messages with MPE then upload to my K750 and send them with the phone disconected from MPE because for some reason my operator classifies the sms sent using MPE as international, even if they are sent to a number of the same operator. MPE modifies the info sent to the operator?
The problem is: the same sms sent to the same number directly from the phone or using MPE has different treatment by the operator!
I wonder if you can help.

[FJ]

Sorry - i don't understand whats the problem

[Gast]

I send a sms from my K750 to a given number: the operator identifies the from and to numbers, verifies both belong to his network and do not charge anything. The sms is free.
If I send the same sms using MPE to the same number as before, the operator does not identify properly and charges me at the max rate. The sms reaches its destination, though.
Of course the problem is with the operator, but MPE for sure adds or modifies some code bit in each sms, otherwise the operator wouldn't notice the diference between sending directly from the phone or using MPE.
I hope I could make myself clear. Thank you for your attention.